Nortel BCM50a - Log command example

Appendix J Log descriptions 307
BCM50a Integrated Router Configuration — Advanced
Use the sys logs display [log category] command to show the logs in an individual
BCM50a Integrated Router log category.
Use the sys logs clear command to erase all of the BCM50a Integrated Router’s
logs.
Log command example
This example shows how to set the BCM50a Integrated Router to record the
access logs and alerts and then view the results.
ras> sys logs load
ras> sys logs category access 3
ras> sys logs save
ras> sys logs display access
# .time source destination notes
message
0|11/11/2002 15:10:12 |172.22.3.80:137 |172.22.255.255:137 |ACCESS BLOCK
Firewall default policy: UDP(set:8)
1|11/11/2002 15:10:12 |172.21.4.17:138 |172.21.255.255:138 |ACCESS BLOCK
Firewall default policy: UDP(set:8)
2|11/11/2002 15:10:11 |172.17.2.1 |224.0.1.60 |ACCESS BLOCK
Firewall default policy: IGMP(set:8)
3|11/11/2002 15:10:11 |172.22.3.80:137 |172.22.255.255:137 |ACCESS BLOCK
Firewall default policy: UDP(set:8)
4|11/11/2002 15:10:10 |192.168.10.1:520 |192.168.10.255:520 |ACCESS BLOCK
Firewall default policy: UDP(set:8)
5|11/11/2002 15:10:10 |172.21.4.67:137 |172.21.255.255:137 |ACCESS BLOCK