132 Chapter 11 Filter configuration
N0115791
Figure 61 Example Filter: Menu 21.1.3.1
When you press [ENTER] to confirm, the screen shown in Figure 62 is displayed.
Note that there is only one filter rule in this set. The screen shows you that you
have configured and activated (A = Y) a TCP/IP filter rule (Type = IP, Pr = 6) for
destination Telnet ports (DP = 23). M = N means an action can be taken
immediately. The action is to drop the packet (m = D) if the action is matched and
to forward the packet immediately (n = F) if the action is not matched, whether or
not there are more rules to be checked (there are none in this example).
Menu 21.1.3.1 - TCP/IP Filter Rule
Filter #: 3,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6 IP Source Route= No
Destination: IP Addr= 0.0.0.0
IP Mask= 0.0.0.0
Port #= 23
Port # Comp= Equal
Source: IP Addr= 0.0.0.0
IP Mask= 0.0.0.0
Port #= 0
Port # Comp= None
TCP Estab= No
More= No Log= None
Action Matched= Drop
Action Not Matched= Forward
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
To Next Page
