Nortel BCM50a - Appendix I Enhanced DHCP option commands; Enhanced DHCP option commands introduction; Specifying the Nortel BCM50 IP address

282
BCM50a Integrated Router Configuration — Advanced
Appendix I
Enhanced DHCP option commands
The following describes the DHCP option commands.
Enhanced DHCP option commands introduction
The enhanced DHCP feature allows you to use DHCP option commands to add
site-specific options to the DHCP server’s offer messages.
Specifying the Nortel BCM50 IP address
Syntax:
ip dhcp <interface> server m50ipreserve [ [ip <IP address>] | [index <index
of pool>] ]
where:
Use this command to specify the IP address that the BCM50a Integrated Router is to
assign to the BCM50.
<interface>
Specify an interface on the device. Currently you can use this
command with the LAN interface (enif0).
[ip <IP address>]
This is the IP address that you want to assign to the Nortel
BCM50.
[index <index of
pool>]
This is the number of an IP address in the BCM50a Integrated
Router’s DHCP server address pool (like one or five) that you
want to assign to the Nortel BCM50.
For example, you would type “2” to assign the second IP
address of the DHCP server pool to the Nortel BCM50.