Chapter 9 Network Address Translation (NAT) 113
BCM50a Integrated Router Configuration — Advanced
Trigger The trigger port is a port (or a range of ports) that causes (or
triggers) the BCM50a Integrated Router to record the IP address
of the LAN computer that sent the traffic to a server on the WAN.
Start Port Enter a port number or the starting port number in a range of
port numbers.
7070
End Port Enter a port number or the ending port number in a range of port
numbers.
7070
Press [ENTER] at the message “Press ENTER to Confirm...” to
save your configuration, or press [ESC] at any time to cancel.
Table 22 Menu 15.3: Trigger Port setup description
Field Description Example
To Next Page
Loading...
