Appendix A - SMC-IO-01 Auxiliary I/O Module
1040-0011 Revision 58
J10 RS-232 Communications
5.3.4 J15 and J16 – MOTF 0 And MOTF 1
The MOTF connectors expose the same signals as the MOTF-0 and MOTF-1 connectors on the SMC
Main Module. Refer to the following for descriptions of these signals:
• Figure 31 - (J15 MOTF Port 0 (X) and J16 MOTF Port 1 (Y)).
• Table 11 - Connector J15 (MOTF-0) Signal Descriptions.
Note: EXT_VCC5V0 is an internally supplied voltage.
For proper functioning of AUX_GPI1_ISO, the signal AUX_GPICOM_ISO on Connector J5, Pin 9 must
be connected to an appropriate source.
To Next Page
Loading...