Appendix B - SMC-LSR-01 IPG Laser Adapter
1040-0011 Revision 68
IPG Laser Adapter Cable Signal Mappings
6.3.2 SMC-LSR-01 Usage with IPG YLP-HP Type B Interface
SMC-LSR-01 is intended to be used with IPG low-power YLP type fiber lasers. A similar connection
scheme is used with IPG YLP-HP high-power fiber lasers with a Type B interface, but with important
differences that prevents direct cabling using this cable adapter without modification. shows how
this cable can be modified or can serve as a guide for creating a discrete wired custom cable.
The expectation is that a PLC or other suitable control mechanism will be connected to the SMC J6
connector and be responsible for safety and fault-mode clearing.
If cable modification is not desirable, then a custom cable can be used between the SMC-LSR-01
adapter 25P D-Sub connector and the laser. The required cable connections are shown in.
To Next Page
Loading...
Need help?
General