Novanta ScanMaster - J13 and J14 - External Motor Control; Extended Outputs Signal Conditioning

Appendix A - SMC-IO-01 Auxiliary I/O Module
1040-0011 Revision 63
+24V
+5V
Internal System Control Signals
EXTAUXOUT{0-7} J7 pins 4-11
EXTAUXOUT{8-15} J9 pins 4-11
16
+24V J7 Pin2 and J9 pin2
J7 & J9 Signals
X 16
GND J7 pin 1 and J9 pin 1
2
2
Extended Outputs Signal Conditioning
5.3.7 J13 and J14 – External Motor Control
Note: These signals are reserved for future use. These ports provide step-and-direction control for
external motor drivers. Input support for an end-of-travel flag is also provided.
Note: EXT_VCC5V0 is an internally supplied voltage.