Novanta ScanMaster User Manual

Table of Contents
4.4 Connector Cross-Reference 21
4.5 SMC Module Connector Pinouts 22
4.5.1 Power Signal Pinouts (Connectors J1 and J3) 23
4.5.2 Serial RS-232 Signal Pinouts (Connector J10) 25
4.5.3 XY2-100 Signal Pinouts (Connector J11) 26
4.5.4 Auxiliary Signal Pinouts (Connector J13) 28
4.5.5 MOTF-1 Signal Pinouts (Connector J14) 33
4.5.6 MOTF-0 Signal Pinouts (Connector J15) 35
4.5.7 Control Signal Pinouts (Connector J16) 36
4.5.8 External Trigger Pinouts (Connector J17) 39
4.5.9 Laser Signal Pinouts (Connector J18) 40
4.5.10 E-STOP (Connector JP6) 44
4.5.11 USB Port 1 Pinouts (Connector J5) 46
4.5.12 USB Port 2 Header Pinouts (Connector J6) 47
4.6 Signal Conditioning 48
4.6.1 Mark-on-The-Fly Inputs – J14 and J15 48
4.6.2 High-speed Laser Synchronization – J18 49
4.6.3 Laser Status 0-5 Signals – J18 49
4.6.4 General Purpose Inputs – J13 and J16 49
4.6.5 System Control Inputs – J13 and J16 50
4.6.6 START Input – J17 and J15 50
4.6.7 System Control Outputs and General Purpose Outputs – J13 and J16 51
4.6.8 Laser Control Outputs – J18 52
4.6.9 Auxiliary XY2-100 Signals – J13 53
5 Appendix A - SMC-IO-01 Auxiliary I/O Module 54
5.1 Introduction 54
5.2 Mechanical Layout 55
5.3 Connectors 55
5.3.1 J3 AND J4 - XY2 - 100 PORTS 55
5.3.2 J11 – RS - 485 Communications 56
5.3.3 J10 – RS – 232 Communications 57
5.3.4 J15 and J16 – MOTF 0 And MOTF 1 58
5.3.5 J6 and J8 – Extended Digital Inputs 59
5.3.6 J7 and J9 – Extended Digital Outputs 61

Novanta ScanMaster Specifications

General

Brand	Novanta
Model	ScanMaster
Category	Controller
Language	English