Appendix C – SMC-LSR-02 SPI Laser Adapter
1040-0011 Revision 75
SPI Laser Connector Signal Assignments
7.3.2 J3 E-STOP Connector
The E-STOP Connector provides access to the SPI LASER_DISABLE_H signal. With an appropriate
jumper inserted, the laser can be enabled without external interlock circuitry. The ESTOP_LOOP
signal is also connected to the SMC through the J18 connector on the SMC. (Refer to Section 4.5.9
("Laser Signal Pinouts (Connector J18)").
Board Connector Type: 3M 37204-62A3-004PL
Mating Connector: 3M 37104-B101-00E-MB
To Next Page
Loading...