Appendix D - SMC-LRS-04 High-power Laser Adapter
1040-0011 Revision 78
8.2 MECHANICAL LAYOUT
High-Power laser adapter mechanical layout
8.3 CONNECTORS
The laser signals from the SMC High-power Laser Adapter are exposed on three connectors: two 12-
pin Phoenix Contact strips and one BNC connector.
Note: Pins 6, 7, and 8 are incorrectly labeled on Rev C of the adapter module. The following table
has the correct pin assignments. This is fixed on later revisions of the adapter card.
To Next Page
Loading...