Table 2-26. Startup sequence (continued)
Controller Step Action Description
3 Apply power to group 1
power supplies.
Enable group 1 power supplies, wait for all members to
report “power good” (if supported):
• 0V85
• 0V9
• 1V2
• 2V1
• 2V5
• OVDD
• EVDD
• USB_SVDD
4 Apply power to group 2
power supplies.
Enable group 2 power supplies, wait for all members to
report “power good” (if supported):
• VDD
• SD_SVDD
5 Apply power to group 3
power supplies.
Enable group 3 power supplies, wait for all members to
report “power good” (if supported):
•
SD_OVDD
• GVDD
• VTT1
• VTT2
6 Complete power sequencer;
trigger reset sequencer.
Control transfers from power to reset handlers.
The power sequencer watches for power switch events
and will restart at power sequencer step 1 if any are
detected.
Reset sequencer 1 Assert all resets. LX2160A PORESET_B is asserted if not already
asserted.
Device resets are asserted:
•
RST_PHY_40GE_B
• RST_PHY_25G_B
• RST_PHY_10G_B
• RST_EPHY[1:2]_B
• RST_SLOT[1:2]_B
• RST_MEM[1:2]_B
• RST_QSFP_B
• RST_XSPI_B
• RST_EMMC_B
• RST_IEEESLT_B
• RST_I2CMUX_B
The LX2160A processor asserts ASLEEP and
HRESET_B in response. ASLEEP is monitored with an
LED, otherwise the signals are ignored.
2 Wait for reset clear. Wait for reset assertion to be released. The reset
sequencer will stall as long as any reset input is
asserted:
•
JTAG_RST_B
• SW_RST_B
3 Sample switches. Internal registers are reset to default values.
Registers that default to switch values are set now.
Table continues on the next page...
Chapter 2 LX2160ARDB Functional Description
QorIQ LX2160A Reference Design Board Reference Manual, Rev. 0, 09/2018
NXP Semiconductors 63
To Next Page
Loading...
