114 Océ 3165 User Manual
Printing multiple files with same settings
When you are printing a range of documents, which require the same settings,
you could temporarily standardize your printer driver from the application you
are using.
Having done so, you can also hide the Océ 3165 print command window, so
that each time you print, you only have to press OK once in the print command
window of the application to send the job to the Network Copier.
Temporarily customizing your printer driver
When you temporarily change the setup, settings are valid as long as your
application is running. Now you only have to click ‘OK’ in the printer window
of your application to start printing immediately
Note: When printing a document, you will notice that several settings which
are defined in the setup window are not available in the print command
window of your application. These settings cannot be changed anymore and
are therefore not shown. They apply, however, to all jobs.
For customizing your printer driver permanently, you should access the setup
window of the Control Panel of your Windows system (see ‘Setting up the
Océ 3165 printer driver’ on page 87).
▼ Setting up the printer driver from your application (Windows)
1
Open the File menu from your application.
2 Select the Print Setup option and select ‘Options’ to display the setup window.
In some applications this setup window can be found within the print window
of the application. Then click the ‘Printer’ box and select ‘Options’.
Note: The temporarily setup window does not contain system setup tabs
such as the ‘General’, ‘Details’ and ‘Capture Settings’ tabs.
3 Define the required settings.
Note: It is not useful to change the number of copies as this setting will be
reset to ‘1’ in the Océ 3165 print window.
4 When finished, click ‘OK’ in the setup window.
5 Select ‘OK’ to close the Print Setup window.
Settings are now valid. When closing the application, settings are lost.
To Next Page
Loading...
