38 Océ 3165 User Manual
Stapling copies
The finisher of the Océ 3165 is provided with a stapler that can automatically
staple up to 35 or 50 sheets of A4 paper weighing 80 g/m
2
(depending on
the machine version).
Copies in other sizes must be stapled by hand. The stapling slot is identified
with a
‘ ’.
If you wish to remove a staple from a stack of copies or originals, you can use
the staple remover which is located in the cover of the automatic document
feeder. This device consists of a pin for opening staples and a tray to collect
the staples.
▼ Automatically stapling a set of copies
1
Place the entire set of originals face down against the left side of the tray in the
automatic document feeder.
Note: The originals must all be the same size and must not be too bent or
wrinkled. See also ‘Originals that can be used’ on page 173. Remove any
paper clips and staples. Make sure all pages are separated from each other.
2 Adjust the original guides if necessary until they are almost against the set of
originals.
3 Indicate whether the originals are 1 or 2-sided and choose 1 or 2-sided copies
using the ‘Original’ and ‘Copy’ function buttons.
4 Using the ‘Staple’ button, select ‘Yes’.
5 Enter the desired number of copies using the copy quantity buttons.
6 Press the start button ( ).
Note: To staple A4 copies automatically, feed the originals in portrait
orientation into the automatic feeder. If the staple is in the wrong corner of
the copies, turn the originals 180°.
▼ Stapling copies by hand
1
Check that no job is in progress.
Attention: If you use the stapler when the machine is processing a finisher
job, this may cause paper jams in the finisher. This, however, does not apply
to machines with a 50 sheet stapler.
To Next Page
Loading...
