Introduction 33
Stopping a job
If the machine is processing a job, you can stop the process at two points:
■ during the scanning of a copy job (the job is aborted immediately)
■ during the printing of a copy or print job (the job is aborted after
confirmation).
In both cases, a new command will be needed if the job (having been
interrupted) is to be continued later.
When operating the Océ 3165 Network Copier, print jobs are processed when
the copier is not being used to make copies. The machine prints all print jobs
in the queue. When a series of print jobs is being printed and you want to make
a copy in between or perform maintenance activities, you can instruct the
Océ 3165 to stop as soon as the current print job is finished. A print job being
printed can also be cancelled. When you do, the job is cleared from the
memory.
▼ Stopping the scanning of a copy job
Press the orange correction button ‘C’.
The Océ 3165 stops scanning and printing the first set of copies. Pages already
scanned are removed from memory. The Océ 3165 is ready for a new job.
▼ Stopping the printing of a copy job
1
Press the red stop button ( ).
The machine reports that the current set of copies or prints will be completed.
Any subsequent job will not be started.
2 If you want to stop immediately, press the stop button ( ) again.
The machine stops printing and the sheets that are still in the machine are
ejected.
3 Press the stop button ( ) once more to confirm the stop command.
The information regarding the job is then removed from memory.
Note: While a print job is announced, you only need to press the stop button
once to delay the print job and make your copies first.
To Next Page
Loading...
