Oce 3165 - Page 77

Installing the Océ 3165 as a printer 77
The Ready to Start Copying window appears.
10 Press ‘Finish’ to continue the installation.
Installation will start and a progress bar will inform you on the status of the
installation.
11 If requested, enter your User, Host and Group name (which will be used for job
identification and copy charges) and click the ‘OK’ button.
Note: A file named “o3165r2.ini” will be added to the Windows directory
which contains your User, Group and Host name. If this file already exists
(because you have installed the driver on this PC before), the fields contain
data saved in the above file. The file data can be changed .
12 The message ‘Installation successful’ appears. If not, contact your system
administrator. You can now finish installation by clicking ‘Continue’ or
configure the printer driver and set defaults by clicking ‘Printer Setup’. When
you finish installation now, you can configure the printer driver afterwards (see
‘Setting up the Océ 3165 printer driver’ on page 87).
13 If you decide to configure the printer driver now, click ‘Printer Setup’.
The Setup window of the printer driver appears.
14 Define the default settings.
Note: For details about setup options, click the ‘Help’ button in the driver
window or refer to ‘Setting up the Océ 3165 printer driver’ on page 87.
15 When finished, click ‘OK’.
16 Click ‘Continue’ to finish installation.
▼ Installing the Océ 3165 (PCL5 and/or PS) printer driver in Windows NT 4.0
1
Start your system (login to the network).
2 Make sure all applications are closed.
3 Insert the floppy disk into your disk drive (A:\) and explore the contents of the
disk.
4 Double-click ‘setup.exe’.
The Oce 3165 Network Copier (PCL5e) printer driver installation window
appears.
5 Select the required language and click ’Next’.
The Printer Installation window pops up. In this window the printer model
which will be used by this printer driver is already entered in the upper entry
box.
6 In the lower entry box, select the network port which will be used for printing
to the Océ 3165 Network Copier. If there is no network port to the Océ 3165
in the pull down menu of this entry box, click ‘Add Network Port’ and browse
to the location of the printer on the network (ask your system administrator for
details). Then, click ‘OK’ to add this port.
7 If required, click the check box ‘Make this the Default Printer’.
8 Click ‘Next’ to proceed installation.