Oce 3165 - Page 84

84 Océ 3165 User Manual
9 Specify printer options. Make sure the number of copies remains specified as
‘1’ and enable banner pages to separate print jobs in the output tray of the
Océ 3165.
Note: The ‘Banner name’ and ‘Banner text’ fields may be left blank, as the
information they may contain is not used.
10 Click ‘OK’ to return to the Network - Printer Connections window, and click
the ‘Close’ button in this window.
11 Click ‘OK’ in the Connect window to return to the Printers window and click
‘Close’ to finalize the MS-Windows Printer Setup.
Quit and restart MS-Windows.
▼ Connecting a port to the Océ 3165 printer queue in Windows 95/NT4.0
1
Click and hold the Start button.
2 Select and hold the option Settings.
3 Select the option Printers (and release the button). The Printers window
appears.
4 Select the Océ 3165 Network Copier icon.
5 Click ‘File’ and ‘Properties’ to open the setup window.
6 Click on the ‘Details’ tab in the setup window.
In the ‘Print to the following port’ entry box, a port is defined.
7 Select another port in the pull down menu, or select ‘Add port’ to browse to
the server name/printer queue on the network. You can also type the server and
printer name ‘\\server name\qname’ in the entry field.
8 Click ‘OK’ to return to the Details tab.
9 When finished, click on ‘OK’ to finalize the setup.
▼ Connecting a port to the Océ 3165 printer queue in Windows NT 3.5x
1
Select and start the Control Panel program by double-clicking the Control
Panel icon (usually available in the Main group).
2 Double-click on the Printers icon in the Control Panel window to open the
Printers window.
3 Select the ‘Océ 3165 Network Copier’ (= printer name as used in the
installation window in figure) from the list of Installed Printers.
4 Click ‘Connect’ to open the Connect window.
The driver is connected to the LPT1-port by default.
5 If required, select another port in the ‘Ports’ list.
6 Click ‘Network’ to open the Network - Printer Connections window.
Note: If all three ports are occupied, you must first disconnect one of them.
7 Select the required ‘LPT’ port (LPT1 in this case), select the server
name/printer queue (e.g. \\fs1\3165q), specify ‘Permanent’ at the Operation
item, and click ‘Connect’.