Installing the Océ 3165 as a printer 97
By default, the substitution table will not be used, which means that all fonts
are sent to the printer as soft fonts and all font information is added to the PS
file. The advantage of sending soft fonts with the print job is that the printed
output looks the same as in the Windows application. The disadvantage is that
it takes more time to send the font over the network. However, if only one or
two fonts are used in a document, the extra time will hardly be a problem
5 Select the ‘Use Substitution Table’ setting to get the best possible fonts with
the smallest file.
The list ‘For System Font’ shows all TrueType system fonts installed on your
PC. The ‘Use Printer Font’ list contains all printer fonts. When you select a
font from the ‘For System Font’ list, a font from the ‘Use Printer Font’ list is
highlighted. The highlighted printer font will be used to replace the selected
system font.
6 Customize the font substitution table to your needs by selecting the best
possible match from the list of printer fonts, or select <soft font> for each of
the TrueType fonts in the list.
Note: When installing additional system fonts on the PC, these will
automatically be added to the list and replaced in this list by a soft font.
7 Apply the changed setup and click ‘OK’ to close the window.
To Next Page
Loading...
