160
Transmitter Battery Removal
Locate the Battery Hatch on the End of the Housing:
Apply a coin to the recessed slot of the Hatch and turn it
counter clockwise out of the Housing (Fig. 147).
Remove the Battery from the Battery Compartment and
discard according to local regulations governing disposal
of Lithium batteries.
Inspection
Closely check all of the sealing surfaces for any signs of
damage that might impair proper sealing.
Inspect the Buttons, Lens, and Housing(s) to ensure they are
not cracked or damaged.
WARNING: If damage or corrosion is found,
return your ATOM system to an Authorized
Oceanic Dealer, and DO NOT attempt to use it
until it has received factory prescribed service.
Remove the Battery Hatch O-ring(s) and inspect them for
any signs of deterioration or deformity. DO NOT use tools
to remove the O-ring(s).
To ensure proper sealing, O-ring replacement is highly
recommended each time a Battery is replaced.
Fig. 147 - TMT BATTERY
HATCH REMOVAL
To Next Page
Loading...
Need help?
General
