Oki MB461 - Page 150

Oki Data CONFIDENTIAL
44871001TH Rev.6
5-13
5. Lubricating point
Portion B, C, D and E For detail
Frame-ADF
EM-30LP Class C
Apply a normal amount of
MOLYKOTE (EM-30LP) to the
hatched area.
(all circumference of post)
SF-133 Class C
Apply a normal amount of HANARL
(SF-133) to the hatched area.
(all circumference of post)
SF-133 Class C
Apply a normal amount of HANARL (SF-133) to the
hatched area.
(all circumference of the sliding surfaces)
Leave it for about 3minutes (drying time ) after painting HANARL SF-133,
and then assemble the ADF-Assy.
Gear-Double-Z26-42
Gear-Planet
Gear-Drivet_Z44
Gear-TL-Sep_Z43-55
Gear-Double-Z31_44
Gear-Double-Z27-55
Gear-Planet_Z19
FN296/7
FX750MLK
Gear-Clutch
Apply to 1 place with range 10mm or more. (The applica-
tion place is arbitrary) It is application to a state without a
lump jumping out of an Gear tooth top, the tooth bottom.
EM-30LP Class D x1
Apply a normal amount of MOLYKOTE (EM-30LP) to the
hatched area. (to 1 places on the gear tooth circle)
(Refer to detail)
EM-30LP Class C
Apply a normal amount of MOLYKOTE
(EM-30LP) to the hatched area.
(all circumference )
EM-30LP Class C
Apply a normal amount of MOLYKOTE
(EM-30LP) to the hatched area.
(to the whole circle of gear tooth)
10mm or more