Oki MB461 - Page 159

Oki Data CONFIDENTIAL
44871001TH Rev.6
6-4
6. MAINTENANCE MENUS
Item1 Item2 Item3 Item4 Item5 Value
Default
value
ODA
Default
value
OEL
Default
value
JP
Notes
Password Scanner
Maintenance
Adjust Scan
Position
ADF
(Front-
side)
Side Reg. +8 ~ -8 mm 0 0 0 Adjusting the position of the scanning start pixel by one Step=4/600 dpi (= 0.17mm) at
the book scanning.
Front Edge +30 ~ -40 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Back Edge +30 ~ -40 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when
skipping the back edge of the document. To read the shadow of the back edge of the
document, add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
ADF
(Back-
side)
Front Edge +30 ~ -40 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Back Edge +30 ~ -40 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when
skipping the back edge of the document. To read the shadow of the back edge of the
document, add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Adjust
ADF Scan
Position
+30 ~ -30 mm 0 0 0 Set the CIS reading position of the ADF for the focusing standard.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm). This is correlated to
adjustment of the ADF front edge position.
Adjust Mech. Adjust FB
Motor
FB Drive
Current
10 ~ 1400 [mA]
300 [mA] 300 [mA]
Only for engineering test
Connect a panel or PC and set the electric current value of the scanner motor.
FB Keep
Current
10 ~ 1400 [mA]
50 [mA] 50 [mA]
Adjust ADF
Motor
ADF Drive
Current 1
10 ~ 1400 [mA]
840 [mA] 840 [mA]
ADF Drive
Current 2
10 ~ 1400 [mA]
740 [mA] 740 [mA]
ADF Drive
Current 3
10 ~ 1400 [mA]
700 [mA] 700 [mA]
ADF Drive
Current 4
10 ~ 1400 [mA]
650 [mA] 650 [mA]