Oki MB461 - Page 208

Oki Data CONFIDENTIAL
44871001TH Rev.6
8-16
8. TROUBLESHOOTING PROCEDURES
Warning
No. Category
PJL Status
Code
Error Warning Description
1 Warning 10081 (K) 1
2
3
4
5
%COLOR% Toner Low
Please see Help for details.
Toner amount is low.
Moreover, when set
as "Admin Setup"-
"Management"-"System
Setup"-"Near Life
LED"=Disable, Alarm
LED is switched off.
%COLOR%
K
3 Warning 10924 (K) 1
2
3
4
5
Please install new %COLOR%
Toner Cartridge.
Please see Help for details.
It shows the toner
cartridge of authorized
3rd party. (RFID Licensed
to 3rd party)
%COLOR%
K
4 Warning 10954 (K) 1
2
3
4
5
%COLOR% Toner Cartridge
Region Mismatch
Please see Help for details.
The Region ID of toner
cartridge is not proper to
the distribution channel.
%COLOR%
K
5 Warning 10950 (K) 1
2
3
4
5
Non Genuine %COLOR% Toner
Cartridge
Please see Help for details.
The chip of RFID is not
compatible.
%COLOR%
K
6 Warning 10076 (K) 1
2
3
4
5
Image Drum Unit Near Life
Please see Help for details.
The life of the drum
(warning). Displayed in
a combination of other
message in the first line.
The printer stops at the
point when it reaches the
drum life (Shifts to error,
OFF-LINE.)
Moreover, when set
as "Admin Setup"-
"Management"-"System
Setup"-"Near Life
LED"=Disable, Alarm
LED is switched off.
No. Category
PJL Status
Code
Error Warning Description
7 Warning 10965 (K) 1
2
3
4
5
%COLOR% Toner Empty
Please see Help for details.
Notifies the toner is
empty. This is a warning
only.
This appears when the
cover was opened and
closed just after the toner
empty error occurred.
%COLOR%
K
8 Warning 10938 (K) 1
2
3
4
5
%COLOR% Toner Cartridge not
installed.
Please see Help for details.
Notifies the toner
cartridge is not installed.
This is a warning only.
%COLOR%
K
9 Warning 10969 (K) 1
2
3
4
5
Please install new Image Drum
Unit.
Please see Help for details.
Notifies the life of the
drum. This is a warning
only.
This appears when the
cover was opened and
closed just after the drum
life error occurred.
10 Warning 10944 (K) 1
2
3
4
5
%COLOR% Head Data Error The LED head calibration
data is missing or invalid.
Printing can be proceeded
without calibrating light
radiation.
PU firmware does not
notify this warning to
CU firmware at the
time of Shipping Mode.
Therefore, this status
does not occur in a user
environment.
%COLOR%
K