Omron F3SG-SR Series - Auto Reset Mode with Wired Synchronization and EDM Unused

F3SG-SR/PG
67
Connections
(Basic Wiring Diagram)
Auto Reset Mode with Wired Synchronization and EDM Unused
[Wiring Example]
Note: For the functional earth connection, refer to page 66.
Beam state: Unblocked
Blocked
OSSD
OSSD (Black) OSSD (White) 24V/0V (Brown) COM(-) (Yellow) TEST (Black)
*2
COM(+) (White) 24V/0V (Brown) 0V/24V (Blue) 0V/24V (Blue) AUX (Red) COM(-) (Pink) COM(+) (Gray)
F39-JGC-L
F39-JGC-D
Timing chart
24 VDC
Wiring for NPN *1
24 VDC
IN1
IN2
RESET/EDM (Yellow)
*3
*6
Receiver
Emitter
Safety controller
*4 *5
Notneeded
IntelligentTap
Function Setting
EDM EDM Disabled (factory default setting)
Interlock Auto Reset (factory default setting)
Operating Range Selection Long (factory default setting) *7
Non-Muting system Perform wiring according to the wiring diagram.
External Test not used Connect the TEST line of the emitter to 0V/24V of the emitter.
Optical Synchronization Connect the COM(+) and COM(-) line of the emitter and receiver with each other.
*1. Reverse the polarity of the power supply when using in the NPN system. Select a safety
controller of PNP or NPN type according to the system of your application.
*2. If External Test is used, refer to the User's Manual (Man.No.Z405).
*3. Connect the line to 24V/0V (brown) of the receiver via a lockout reset switch (NC contact) if
Lockout Reset is used.
*4. Refer to page 75 for more information.
*5. The safety controller and the F3SG-SR must share the power supply or be connected to the
common terminal of the power supply.
*6. This is the case for a PELV circuit.
*7. The Intelligent Tap is needed to set the Short mode. Set the function with the DIP Switches on
the Intelligent Tap or the SD Manager 3, restore the settings to the F3SG-SR, and perform
wiring according to the wiring diagram.