Omron F3SG-SR Series - Troubleshooting F3 SG-SR LOCKOUT State; F3 SG-SR LOCKOUT State Troubleshooting

Dimensions
Troubleshooting
F3SG-SR/PG
95
Troubleshooting
F3SG-SR
LOCKOUT State
Identify an error according to the combination of the indicators when the error occurs. See the following troubleshooting tables to take measures.
For detail, Refer to User’s Manual (Man. No. Z405).
Illuminated Blink
Combination of indicators and error description
<Indicator status at lockout: Receiver>
DIP Switch setting error
Operating range selection setting error
TOP
Cap error
Other sensor error
Communication error
Error other than those above
*1 *3
*2 *3
BTM
L
or
LONG
E
or
ERR
Blinking once
ERR indicator
Blinking once
E
or
ERR
Blinking once
--- ---
---
E
or
ERR
[Error description]
M
or
MAINT
M
or
MAINT
Recoverable error
Red blinking : Replacement-recommended error
Orange blinking
O
or
OSSD
P
or
PNP
F
or
CFG
TOP
*1
BTM
*2
O
or
OSSD
Error due to change of PNP/NPN
polarity during operation
Cap error
Other sensor error
DIP Switch setting error
Blanking monitoring error
Configuration error
Parameter error
Safety output error due to power
supply voltage or noise
Communication error
External device monitoring error
Error other than those above
Intelligent Tap error
---
Safety Output error
E
or
ERR
Blinking twice
MAINT indicator
*
1. For F3SG-SRA, the Area Beam Indicator closer to the "TOP" mark on the F3SG-SR blinks.
*
2. For F3SG-SRA, the Area Beam Indicator closer to the "BTM" mark on the F3SG-SR blinks.
Combination of indicators and error description
<Indicator status at lockout: Emitter>
ERR indicator
Other indicators
Error description
*
1. For F3SG-SRA, the Area Beam Indicator closer to the "TOP" mark on the F3SG-SR blinks.
*
2. For F3SG-SRA, the Area Beam Indicator closer to the "BTM" mark on the F3SG-SR blinks.
*
3. The indicator blinks only in the case the Wired Synchronization is enabled and is off in the case the Optical Synchronization is enabled.
Other indicators
Error description