9
Simple wiring for flexible design
Two different synchronization systems
* Available soon
The F3SG-PG* Perimeter Guarding Deflect Mirror only requires wiring to one end for protection
around perimeters of equipment, reducing wiring duct design and wiring time.
Choose from two different methods of
synchronization between the emitter and receiver to suit your equipment.
Optical synchronization Wired synchronization
No sync lines are required.
Connect emitter only to
power supply.
Mutual interference
prevention : Up to 2 sets
Mutual interference
prevention : Up to 3 sets
Passive mirror
Emitter/receiver
Emitter/receiver Passive mirror
Mirror column No wiring
required
Power supply
No wiring to
control panel
required
Mutual
interference
prevention
up to 3 sets
To Next Page
Loading...
Need help?
General
