Functions and Operations
Section 5 Functions and Operations
5-40
Changing display refresh periods → P.5-73
B
Press the
L
[LEVEL] Key once (less
than 1 s) to move to the input adjustment
level.
Less
than 1 s
•“L 1” is displayed on the level/bank
display to indicate the input
adjustment level.
C Press the M [MODE] Key several times
to switch the PV display to “avg-t.”
D Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
E Use the U [UP] Key to change the
average type setting.
F Press the M [MODE] Key to change to
the next parameter “avg-n.”
•
The average type setting is registered.
G Press the S [SHIFT] Key to make the
SV display flash.
H Use the U [UP] Key to change the
averaging times setting.
I Press the M [MODE] Key to switch to
the next parameter.
• The averaging times setting is
registered.
J Press the L [LEVEL] Key for at least
1 s to return to RUN level.
1 s min.
L
tmg-h
Displays “L 1."
nomal
L 1
M
avg-t
smpl
L 1
S
avg-t
smpl
L 1
U
avg-t
move
L 1
M
avg-n
1
L 1
S
avg-n
1
L 1
U
avg-n
4
L 1
M
memo
off
L 1
L
1234. 5
1234. 5
Remarks
To Next Page
Loading...
