Omron K3HB-H - Page 168

Functions and Operations
5.38 Using Comparative Set Value Banks
5-95
One Point
■ 2. Setting the Comparative Set Values for Each Bank
Once the bank selection method has been specified, set the
comparative set values for each bank.
Comparative set values are set using the following parameters.
∗ 0 to 7
The decimal point depends on the “decimal point position” parameter setting.
Parameter Setting Procedure
I Press the L [LEVEL] Key for at least
1 s to return to RUN level.
1 s min.
“B” is lit to indicate that
the bank is enabled.
L
123. 4
123. 4
B
Parameter Set value Meaning of set value
Comparative set value ∗ HH
sv ∗ .hh
-19999 to
99999
-19999 to 99999
Comparative set value
∗H
sv
∗.h
-19999 to
99999
-19999 to 99999
Comparative set value
∗L
sv
∗.l
-19999 to
99999
-19999 to 99999
Comparative set value
∗LL
sv
∗.ll
-19999 to
99999
-19999 to 99999
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
3 s min.
• “ L 0 ” is displayed on the level/bank
display to indicate the initial setting level.
B Press the L [LEVEL] Key several times to
move to the comparative set value level.
•“L 4" is displayed on the level/bank
display to indicate the comparative
set value level.
C Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U [UP] Key to select the bank
to be set.
E Press the M [MODE] Key.
•
The bank selected in step D can be set.
sv∗. hh
L 4
(SV∗.HH)
sv. bnk
L 4
(SV.BNK)
copy
L 4
(COPY)
sv∗. ll
L 4
(SV∗.LL)
∗ 0 to 7
sv∗. l
L 4
(SV∗.L)
sv∗. h
L 4
(SV∗.H)
L
Displays “L 0.”
L 0
L
sv. bnk
Displays “L 4."
0
L 4
S
sv. bnk
0
L 4
U
sv. bnk
1
L 4
M
sv1. hh
99999
L 4