Omron K3HB-H - Page 20

Outline
1.1 Main Functions and Features of the K3HB
1-3
Key operations
Outputs
Teaching Key protection
During scaling, the input value
during measurement can be
set, as is, as the scaling input
value.
→ P.5-14
(Setting Scaling)
Limits key-operated level and
parameter changes to prevent
inadvertent key operations and
malfunctions.
→ P.5-102
Comparative output pattern Hysteresis Output refresh stop
The comparative output
pattern can be selected as
standard output, zone output,
and level output.
→ P.5-44
Prevents comparative output
chattering when the
measurement value fluctuates
slightly near the set value.
→ P.5-46
Holds the output status when
comparative results outputs
other than PASS turn ON.
→ P. 5 - 5 2
PASS output change Output OFF delay Shot output
Comparative results other
than PASS and error signals
can be output from the PASS
output terminal.
→ P.5-57
Connects the comparative output
OFF timing for a set interval.
Comparative output ON times can
be held when comparative results
change quickly.
→ P.5-55
Produces a constant
comparative output ON time.
→ P. 5 - 4 9
Output logic Startup compensation timer Output test
Reverses the output logic of
comparative outputs for
comparative results.
→ P.5-59
Constant-time measurements
can be stopped by an external
signal input.
→ P.5-27
Output operation can be
confirmed without actual input
signals, by setting test
measurement values using
the keys.
→ P. 5 - 9 0
Linear output Standby sequence
Outputs currents or voltages
proportional to measurement
values as they change.
→ P.5-65
Turns the comparative output
OFF until the measurement
value enters the PASS range.
→ P.5-61
X V S
X V S
H
X V S
H
X V S
H
X V S
H
X V S
H
X V S
H
X V S
H
X V S
H
X V S
H
X V S
H
X V S
H