Functions and Operations
Knowledge Required for Setting Parameters
5-7
■
Confirming and Changing Comparative Set Values
Comparative set values are confirmed and changed in RUN level.
(The Unit keeps operating even while comparative set values are
being confirmed and changed.)
The comparative set values from HH to LL are displayed each time the
M[MODE] Key is pressed in the operation status immediately after the
power is turned ON. The SV display status is lit for the
displayed comparative set value.
Some comparative set values may not be displayed, depending on the
relay/transistor output specifications and settings.
Refer to the parameter setting procedures for information on how to
change comparative set values.
Displayed comparative set value
* For Sensor Power Supply/Output models with a PASS output, the
displayed comparative set value changes depending on the
allocation setting of the PASS output.
Allocating other outputs to PASS output → P.5-49
* When sv.
dsp (comparative set value display) is set to OFF,
comparative set values are not displayed during operation but are
displayed with key operations.
Displayed comparative set value
Relay/transistor output specifications
HH H L LL
H/L Models with Relay Outputs
<C1>
HH/H/L/LL Models with Relay
Outputs <C2>
HH/H/PASS/L/LL Models
with transistor output <T1><T2>
None *
Displayed comparative set value
pass (PASS output change)
HH H L LL
ll
l
pass
h
hh
err.
HH H L LL
Power ON
Monitor
status
Change
status
*
2
Comparative
set value HH
HH
Lights
M
Comparative
set value H
H
Lights
M
Comparative
set value L
L
Lights
M
Comparative
set value LL
LL
Lights
125.
0
123. 4
124. 0
123. 4
123. 0
123. 4
122. 0
123. 4
S
M
MM
125. 0
123. 4
124. 0
123. 4
123. 0
123. 4
122. 0
123. 4
*
1
*
1
*
1
*
1
S
SS
M
*1
If no key is pressed for 5 seconds, the set value is registered and the display returns to monitor status.
*2 Use the S[SHIFT] and U[UP] Keys to set the set value.
M
Remarks
To Next Page
Loading...
