Omron OS32C Series - Troubleshooting

106
Chapter4
OS32C
User’s Manual
Installation
 OS32C with XY Axis Rotation Mounting Kit Dimensional Drawing
Fig. 4-30 Dimensional drawing of OS32C with OS32C-BKT1 and OS32C-BKT2
 OS32C with XY Axis Rotation Mounting Kit Assembly Drawing
Fig. 4-31 Assembly drawing of OS32C with OS32C-BKT1 and OS32-BKT2
50.0 [1.97]
55.9 [2.20]
132.7 [5.23]
151.1 [5.95]
163.7 [6.45]
28.2 [1.11]
95.2 [3.75]
SCAN PLANE
102.4 [4.03]
37.0 [1.46]
54.5 [2.15]
119.7 [4.72]
111.4 [4.39]
93.5 [3.68]
99.2 [3.91]
17.0 [0.67]
48.0 [1.89]
46.0 [1.81]
166.3 [6.55]
163.0 [6.42]
150.5 [5.93]
43.0 [1.69]
15.0°
15.0°
42.2 [1.66]
17.4 [0.69]
7.5 °
7.5°
BACK VIEW
BOTTOM VIEW
SIDE VIEW
(FOR BACK MOUNTING)
HARDWARE FOR
Y-ADJUSTMENT
(FOR Y-ANGULAR ADJUSTMENT)
BACK VIEW
DIMENSIONS: mm [Inches]
4-5.3 [0.21] dia.
4-5.3 [0.21] dia.
6.4 [0.25]
2-R72.0 [2.83]
R47.5 [1.87]
HARDWARE
X-ADJUSTMENT
FOR
MTG SCREWS
(x3)(M5 x 10)(EACH SIDE)
WASHERS, SPLIT
(x3) (M5) (EACH SIDE)
WASHERS, FLAT
(x3) (M5) (EACH SIDE)
IS REQUIRED
MOUNTING UNIT,
IF Y-ADJUSTMENT
Y-ADJUSTMENT.
INSTALL BEFORE
HARDWARE FOR
WASHER, FLAT
(x1) (M5)
WASHER, SPLIT
MTG SCREW
(x1) (M5)
(x1) (M5 x 16)
BRACKET #2
OS32C LASER SCANNER UNIT,
WITH BOTTOM/SIDE MOUNTING KIT
MODEL OS32C-BKT1
(x4) HOLES FOR M5 MOUNTING
SCREWS AND FLAT WASHERS,
HARDWARE USER SUPPLIED
HARDWARE USER
SUPPLIED
(x4) HOLES FOR
M5 MOUNTING SCREWS
AND FLAT WASHERS,
FOR BOTTOM MOUNTING
FOR Y-ANGULAR ADJUSTMENT
(X3) SLOTS
USE M6 HEX HEAD SCREWS,
SPLIT AND FLAT WASHERS
HARDWARE USER SUPPLIED *
* In order to comply with Section 4.2.16 of IEC 61496-3,
when the OS32C is mounted where the scanner position
could change (e.g. as the result of an impact), additional
mechanical means, such as serrated or toothed lock
washers, must be employed in the mounting hardware.