107
OS32C
User’s Manual
Chapter4
Installation
E
OS32C with XY Axis Rotation Mounting Kit and Top Guard Dimensional Drawing
Fig. 4-32 Dimensional drawing of OS32C with OS32C-BKT1 and OS32C-BKT2 and OS32C-BKT4
OS32C with XY Axis Rotation Mounting Kit and Top Guard Assembly Drawing
Fig. 4-33 Assembly drawing of OS32C with OS32C-BKT1 and OS32C-BKT2 and OS32C-BKT4
50.0 [1.97]
55.9 [2.20]
141.0 [5.55]
107.5 [4.24]
93.5 [3.68]
48.0 [1.89]
150.5 [5.93]
42.2 [1.66]
17.4 [0.69]
7.5°
54.5 [2.15]
163.7 [6.45]
119.7 [4.72]
46.0 [1.81]
15.0°
151.1 [5.95]
95.2 [3.75]
SCAN PLANE
163.0 [6.42]
102.4 [4.03]
37.0 [1.46]
99.2 [3.91]
43.0
[1.69]
111.4 [4.39]
168.4 [6.63]
DIMENSIONS: mm [Inches]
BACK VIEW
(FOR BACK MOUNTING)
HARDWARE FOR
Y-ADJUSTMENT
(FOR Y-ANGULAR ADJUSTMENT)
BACK VIEW
SIDE VIEW
BOTTOM VIEW
7.5°
166.3 [6.55]
17.0
[0.67]
28.2
[1.11]
4.8
[0.19]
15.0°
6.4 [0.25]
4-5.3 [0.21] dia.
2-R72.0 [2.83]
R47.5 [1.87]
4-5.3 [0.21] dia.
WITH TOP GUARD KIT MODEL OS32C-BKT4
WITH BOTTOM/SIDE MOUNTING KIT MODEL OS32C-BKT1
(X1) (M5)
WASHER, SPLIT
MTG SCREW
(X1) (M5 x 16)
WASHER, FLAT
(X1) (M5)
MOUNTING UNIT,
IF Y-ADJUSTMENT
OS32C LASER SCANNER UNIT
Y-ADJUSTMENT.
INSTALL BEFORE
HARDWARE FOR
IS REQUIRED
BRACKET #2
(X3) (M5 x 10) (EACH SIDE)
(X3) M5 (EACH SIDE)
(X3) M5 (EACH SIDE)
WASHERS, SPLIT
WASHERS, FLAT
MTG SCREWS
FOR
X-ADJUSTMENT
HARDWARE
(X4) HOLES FOR M5 MOUNTING
SCREWS AND FLAT WASHERS,
HARDWARE USER SUPPLIED
FOR Y-ANGULAR ADJUSTMENT
(X3) SLOTS
USE M6 HEX HEAD SCREWS,
SPLIT AND FLAT WASHERS
HARDWARE USER SUPPLIED *
FOR BOTTOM MOUNTING (X4) HOLES
FOR M5 MOUNTING SCREWS
AND FLAT WASHERS,
HARDWARE USER
SUPPLIED
* In order to comply with Section 4.2.16 of IEC 61496-3,
when the OS32C is mounted where the scanner position
could change (e.g. as the result of an impact), additional
mechanical means, such as serrated or toothed lock
washers, must be employed in the mounting hardware.
To Next Page
Loading...
