RUN Mode Section 4-3
117
n Releasing the Zero Reset
4-3-5 Other RUN Mode Functions
n Timing Input
The timing input is controlled by pressing the UP Key ( ).
The timing input is enabled only in Hold Mode.
The timing input can also be controlled using the external timing input.
n Reset Input
The reset input is controlled by pressing the DOWN Key ( ).
The reset input is effective when the key is pressed for 3 seconds or
longer.
The reset input can also be controlled using the external reset input.
When the reset input is used, operation will be according to setting for non-
measurement table in Reset Input under 3-2-1 Inputs.
Refer to Reset Input under 3-2-1 Inputs.
Set the mode switch to RUN.
Hold the ENT and RIGHT Keys down
together for about 3 seconds when the
zero point has been reset.
The zero reset can also be released
using the external zero reset input. The
operation can be repeated as required.
RUN T FUN
The previous display will be resumed
and the zero reset indicator will turned
OFF.
Hold the ENT and RIGHT
Keys down together for
about 3 seconds.
+
To Next Page
Loading...
