Procedures for Reflective Sensor Heads
Section 2-3
22
2-3 Procedures for Reflective Sensor Heads
2-3-1 Positioning and Setting Threshold Values
Manual Setting
3-4-2 Inputting Threshold Values Directly
Automatic Setting
l Workpiece surface positioning:
Position Teaching in 3-4-1 Teaching
l Unknown size workpiece judgement:
Two-point Teaching in 3-4-1 Teaching
l Judging workpiece with uneven surfaces, warped workpieces, or mov-
ing workpieces:
Automatic Teaching in 3-4-1 Teaching
2-3-2 Setting Various Functions
l Changing the display value:
3-5-1 Scaling
l Changing response speed or increasing resolution:
3-5-2 Number of Samples to Average
l Changing positioning accuracy when operating and releasing:
3-5-3 Hysteresis Setting
l Holding value during measurement:
3-5-4 Hold Functions
l Using OFF-delay timer:
3-5-5 Timer
l Operation requiring two Sensor Heads:
3-5-6 Two-sensor Operation
l Resetting default status:
3-5-7 Initializing Settings
l Changing the output current or voltage range:
Special Functions (Set)
3-5-8 Monitor Focus Function
l Detecting the optical level:
Special Functions (Set)
3-5-9 Intensity Mode
To Next Page
Loading...
