Omron ZX Series User Manual

Through-beam Sensor Heads: T Mode Functions Section 3-7
78
3-7-2 Inputting Threshold Values Directly
The threshold values can be directly input into the sub-display.
Note: Generally, any value can be input. The judgement outputs, however, will
not operate for thresholds that are outside the measurement range. Also,
the decimal point cannot be changed.
If an error occurs when inputting a threshold value, refer
to 4-4-2 Inputting Threshold Values Directly and 5-2-3
Unable to Set Threshold Values.

Omron ZX Series Specifications

General

Power Supply Voltage	12 to 24 VDC ±10%
Protection Rating	IP67
Output Type	NPN or PNP
Protection Circuit	Reverse polarity protection, short-circuit protection
Operating Temperature	-25 to 55°C (-13 to 131°F)