Omron ZX Series User Manual

FUN (Function) Mode Section 4-5
139
4-5-13 Auto-scale Settings
The auto-scale setting procedure is shown in the following figure. This
function can be set only for a Through-beam Sensor.
No. of samples
to average
Scaling function
Auto-scale
Go to the
next mode
.
Press the ENT Key to
complete the auto-
scale
setti
ng.
Move to the scaling function
selection mode.

Omron ZX Series Specifications

General

Power Supply Voltage	12 to 24 VDC ±10%
Protection Rating	IP67
Output Type	NPN or PNP
Protection Circuit	Reverse polarity protection, short-circuit protection
Operating Temperature	-25 to 55°C (-13 to 131°F)