The job setup screen is organized in a natural workflow from top to bottom, but
most steps and settings can be accessed in any order. The default values display
for each step and setting. Tap on the step number or heading to expand the
section and view or change the settings.
If only one source and one destination are connected, they are automatically
selected. If you are satisfied with the default settings and the selected Source and
Destination(s) drives, press the Start Duplication button at the bottom of the
screen to begin the job.
3. To modify or enter job notes, tap the 1 or Job Notes heading to expand the
section. Tap a text box to modify or enter Name, Case ID, or Notes values and
the virtual keyboard is displayed on the bottom half of the screen. If desired, you
can also attach a USB keyboard to one of the front Accessory USB ports to make
data entry easier.
Chapter 4 Using TX1
78
OpenText™ Tableau™ Forensic TX1 Imager
ISTX240300-UGD-EN-1
To Next Page
Loading...
