If any source drives were previously connected to the system and the Acquire
Currently Connected option was set in step 3 above, then a job will be started or
queued for each of the connected drives.
If no source drives were previously connected to the system or the Acquire
Currently Connected option was disabled in step 3 above, then no automated
jobs will be started until a new source drive is detected by the system.
It is important to note that, while in Automated Acquisition mode, new jobs can
still be manually added, and they will run as soon as their required resources are
available.
Any jobs that were automatically started by the system will show (Auto) next to
the checkmark on the drive tile that indicates a drive was acquired (or is being
acquire, in the case of a hollow checkmark). This helps you keep track of which
jobs were manually or automatically initiated.
Note that automated acquisition jobs will never take you directly to the Job
Status screen. These jobs are always shown in the Jobs tab as Automated
(instead of Duplication or Logical), and their Job Status screen can be viewed at
any time by tapping on the job row in the Jobs tab.
Automated Acquisition mode can be stopped by tapping the Cancel button on
the right side of the Automated Acquisition job tile in the Jobs tab. Automated
Acquisition job setup does not persist over a power cycle.
4.3. Duplicating
ISTX240300-UGD-EN-1
User Guide
93
To Next Page
Loading...
