Error retry defines the number of times TX1 will attempt to read sectors with
errors before skipping the sector. Be careful when selecting a value of 10 or 100
as it will drastically increase the duplication time when imaging source drives
with errors.
7. To change the image settings, tap the 5 or Image Settings heading.
Image name defines the base filename for image segments. The default value is
image. Tap the Image name text area to change the filename, then select a File
format and File size.
Compression is enabled by default for ex01 and e01 file formats but can be
disabled if desired. Compression is not supported for dd and dmg file formats.
8. Once you are satisfied with your settings and drive selections, tap the ENABLE
AUTOMATED ACQUISITION button. The Jobs tab will be shown with
information in the top Automated Acquisition area indicating that mode is
active ‒ the file type setting for all automated jobs and the number of automated
jobs that have been started during the active automated acquisition job. Note
that the automated acquisition indicator will be rotating in the Jobs tab header
area next to the active/queued job count. This allows for at-a-glance awareness
that automated acquisition mode is active, even when not looking at the Jobs tab.
Chapter 4 Using TX1
92
OpenText™ Tableau™ Forensic TX1 Imager
ISTX240300-UGD-EN-1
To Next Page
Loading...
