C200 HARDWARE
Instruction Manual C200 Part1 A1.doc
optek Danulat GmbH • D-45356 Essen • Germany
page 7
Accuracy: ±0.25% FSD, ±5% of reading (whichever is the greater)
Resolution: 0.1% at 10mA, 0.05% at 20mA
Maximum load resistance: 750 at 20mA
Configuration: Can be assigned to either measured variable or either sample
temperature
Access to Functions
Direct keypad access: Measurement, maintenance, configuration, diagnostics and
service functions
Performed without external equipment or internal jumpers
Control Function – C210 and C220 only
Controller Type: P, PI, PID (configurable)
Output: Can be assigned a maximum of two relays, two analog outputs
or one of each
Analog: Current output control (0 to 100%)
Time proportioning cycle time: 1.0 to 300.0s, programmable in increments of 0.1s
Pulse frequency: 1 to 120 pulses per minute, programmable in increments of
1 pulse per minute
Controller action: Reverse, direct or bi-directional (programmable)
Proportional band: 0.1 to 999.9%, programmable in increments of 0.1%
Integral action time (Integral reset): 1 to 7200s, programmable in increments of 1s (0 = Off)
Derivative: 0.1 to 999.9s programmable in increments of 0.1s, available
only for single set point control
Auto/Manual: User-programmable
To Next Page
Loading...
