Optek CONTROL 200 - Configure Logbook; Configure Security

C200 SOFTWARE
Instruction Manual C200 Part2 A1.doc
optek Danulat GmbH • D-45356 Essen • Germany
page 83
5.2.8 Configure Security
Alter Security Code
Set the security code to a value between 0000 and 19999.
Alter Calibration Code
Set the sensor calibration access code to a value between 0000 and 19999.
Return to main menu.
Option board fitted and analog features enabled (Section 6.2.3) –
see Section 5.2.9.
5.2.9 Configure Logbook
Note. The Configure Logbook function is available only if the option board is fitted and analog features enabled –
see Section 6.2.3.
Configure Logbook
Use the and keys to to set the logbook On or Off.
If Off is selected, all data entries in the logbook are cleared.
Return to main menu.
See Section 5.2.10.
Alter Sec. Code
0000
Alter Cal. Code
0000
CONFIG. SECURITY
-----
CONFIG. LOGBOOK
CONFIG. SECURITY
Alter Sec. Code
Logbook
-----
CONFIG. LOGBOOK
-----
TEST/MAINTENANCE
CONFIG. LOGBOOK
Off
On