Optek CONTROL 200 - Configure Control

C200 SOFTWARE
Instruction Manual C200 Part2 A1.doc
optek Danulat GmbH • D-45356 Essen • Germany
page 78
5.2.7 Configure Control
Notes.
• PID control is applicable only to single input analyzers.
• Before configuring the PID controller, refer to Appendix B for further information.
Controller Type
Select the controller type:
Off – Disables the controller
PID – Single PID controller
Controller set to PID – see Section 5.2.7.1.
See Section 5.2.8.
CONFIG. CONTROL
-----
Controller
PID Controller
PID
Off
-----
CONFIG. SECURITY