Optek CONTROL 200 - Programming; Programming Ph; Security Code

C200 SOFTWARE
Instruction Manual C200 Part2 A1.doc
optek Danulat GmbH • D-45356 Essen • Germany
page 43
5 Programming
5.1 Programming pH
5.1.1 Security Code
Note. This frame is displayed only if Alter Sec. Code is not set to zero – see Section
5.1.8.
Enter the required code number (between 0000 and 19999), to gain access to the
configuration pages. If an incorrect value is entered, access to the configuration
pages is prevented and the display reverts to the Operating Page – see Section
2.1.2.
See Section 5.1.2.
SECURITY CODE
0000
CONFIG. DISPLAY