Optek CONTROL 200 - C200 S Oftware

C200 SOFTWARE
Instruction Manual C200 Part2 A1.doc
optek Danulat GmbH • D-45356 Essen • Germany
page 4
Table of contents page
1 Overview Hardware 6
1.1 Front panel CONTROL 200 6
1.2 Connection feasibilities 7
2 Operation 8
2.1 Operation pH 8
2.1.1 Menu structure 8
2.1.2 Operating page 10
2.1.2.1 Single Input pH 10
2.1.2.2 Dual Input pH 11
2.1.2.3 Single Input Redox (ORP) 12
2.1.2.4 Dual Input Redox (ORP) 13
2.1.2.5 Dual Input pH and Redox (ORP) 14
2.1.2.6 Wash function 15
2.2 Operation conductivity 16
2.2.1 Menu Structure 16
2.2.2 Operating page 18
2.2.2.1 Single Input 4-Pole Conductivity 18
2.2.2.2 Dual Input 4-Pole Conductivity 19
3 Operator Views 20
3.1 Operator Views pH 20
3.1.1 View Setpoints 22
3.1.2 View Outputs 22
3.1.3 View Hardware 23
3.1.4 View Software 24
3.1.5 View Logbook 26
3.1.6 View Clock 27
3.2 Operator Views conductivity 27
3.2.1 View Setpoints 28
3.2.2 View Outputs 28
3.2.3 View Hardware 29
3.2.4 View Software 29
3.2.5 View Logbook 31
3.2.6 View Clock
4 Setup 32
4.1 Sensor Calibration pH 32
4.1.1 Set Buffer Type 32
4.1.2 Set Up User Defined Buffers 34
4.1.3 Adjust Offset 35
4.1.4 Automatic, Single- and Two-Point Calibration 36
4.1.5 Manual, Single- and Two-Point Calibration 38
4.1.6 Grab Calibration 40
4.2 Sensor Calibration Conductivity 41
5 Programming 43
5.1 Programming pH 43
5.1.1 Security Code 43
5.1.2 Configure Display 44
5.1.3 Configure Sensors 45
5.1.4 Configure Diagnostics 48
5.1.5 Configure Alarms 49
5.1.5.1 Wash Cycle Configuration 51