C200 SOFTWARE
Instruction Manual C200 Part2 A1.doc
optek Danulat GmbH • D-45356 Essen • Germany
page 5
5.1.6 Configure Outputs 53
5.1.7 Configure Clock 55
5.1.8 Configure Security 56
5.1.9 Configure Logbook 56
5.1.10 Test Outputs and Maintenance 57
5.2 Programming Conductivity 59
5.2.1 Security Code 59
5.2.2 Configure Display 60
5.2.3 Configure Sensors 61
5.2.4 Configure Alarms 68
5.2.4.1 Configure Standard Alarms 68
5.2.4.2 Configure CIP Interface Alarm 70
5.2.4.3 Configure CIP Status Alarm 72
5.2.5 Configure Outputs 75
5.2.6 Configure Clock 77
5.2.7 Configure Control 78
5.2.7.1 Configure Single PID Controller 79
5.2.7.2 Configure Power Failure Recovery Mode 82
5.2.8 Configure Security 83
5.2.9 Configure Logbook 83
5.2.10 Test Outputs and Maintenance 84
6 Calibration 86
6.1 Calibration pH 86
6.1.1 Equipment Required 86
6.1.2 Preparation 87
6.1.3 Factory Settings 88
6.2 Calibration Conductivity 93
6.2.1 Equipment Required 93
6.2.2 Preparation 94
6.2.3 Factory Settings 95
7 Fault Indication 101
7.1 Fault Finding pH 101
7.1.1. Error Messages 101
7.1.2. Calibration Fail Message or no Response to pH/Redox Changes 102
7.1.3. Checking the Temperature Input 102
7.2 Fault Finding conductivity 103
7.2.1 Error Messages 103
7.2.2 Calibration Fail Message or no Response to Conductivity Changes 103
7.2.3 Checking the Temperature Input 104
8 Appendix 105
8.1 Buffer Solutions pH 105
8.2 Automatic Temperature compensation 107
8.3 PID Controller 108
9 Certificates 112
10 Fax-Reply Form 113
Part 1 - Hardware (refer to separate documentation)
To Next Page
Loading...
