reference;
If there is a lot of grass, mow it twice. Try
to mow at a higher mowing height first,
and then mow at a lower mowing height
and mow again.
① Be sure to mow the grass with the knife replacement cover
on the right side of this product closed.
② Start the engine.
③ Set the throttle lever to the high speed position and
increase the engine speed.
④ First, adjust the cutting height adjustment lever to the
cutting height position of about 70 mm.
Adjust the lever position referring to the scale display.
⑤ Then slowly tilt the knife clutch lever to the "on" position.
⑥ Fine-tune the cutting height adjustment lever again to the
required cutting height.
⑦ Start this machine and start work.
⑧ To finish the work, reverse the above procedure.
⑨ Please stop the engine.
1) Continuing to work with grass accumulated around the engine may cause a fire or engine seizure.
Frequently remove grass debris that has accumulated around the exhaust pipe, which is
particularly hot. Also, clean the inside of the engine cover regularly as well as the outside.
To Next Page
Loading...
