4.運転・作業のしかた
- 29 -
2) The cut grass is spit out from the knife replacement cover on the right side of this product, but
foreign matter such as stone blocks, wires, empty cans, etc. may be scattered from the entire of
the cutting part and cause damage to the surroundings. In fields near buildings or in fields with
a lot of foreign matter, remove them before work and mow high or to prevent people (especially
children), vehicles, etc. from entering the work area. Do not bring these things close to each
other at a sufficient distance of 15 m or more, such as by putting up a preventive net.
3) If the cooling part is clogged with mud or dust, the oil temperature of the engine and HST will rise.
Requires regular maintenance.
4) Be careful not to approach dangerous places such as obstacles, gutters, soft shoulders, slopes
(gradient of 10 ° or more), and unevenness of the ground in the field. To prevent falls and
collisions, do not work in the direction of buildings, rivers, cliffs, or people.
5) When working on slopes, it is especially dangerous to stand on the upper side (mountain side) of
this product. If you slip your foot, you may get caught in a rotating knife and get seriously injured.
6) Always stop the engine and make sure the knife has stopped spinning before removing any grass,
wires or other foreign objects that may be entangled in the knife.
7) Do not start the work until you confirm that the part where the defect was confirmed in the
previous work has been repaired.
8) For safe work, please perform pre-work inspection of knives and knife stays with reference to <5.4
Knife inspection / replacement / installation>.
9) Be sure to use the attached special tool to attach and detach the knife. If it is not used, sufficient
tightening torque cannot be obtained, and there is a risk that the knife will scatter due to the
mounting bolt falling off.
10) Be sure to use the attached special tool to attach and detach the knife. If it is not used, sufficient
tightening torque cannot be obtained, and there is a risk that the knife will scatter due to the
mounting bolt falling off.
11) Be sure to use the attached special tool to attach and detach the knife. If it is not used, sufficient
tightening torque cannot be obtained, and there is a risk that the knife will scatter due to the
mounting bolt falling off.
12) The unit may slip when the grass is wet or when it rains. In addition, the mowing will clog the
inside of the mowing deck, etc., which will overwhelm the engine.
In such a case, stop the work and start the work after the grass has dried.
13) While the knife is rotating, the knife will reach the inside of the covers on both the left and right
sides, so be sure not to put grass etc. into the cutting deck with your hands or feet during work.
〈Refer to the below figure〉
To Next Page
Loading...
