4.運転・作業のしかた
- 30 -
1) For work clothes, wear long-sleeved jackets and trousers with a squeezed hem, and be
sure to wear non-slip boots, a hat or helmet, dust-proof glasses, and protective gloves.
2) Remove foreign objects such as stumps, stone blocks, wires, empty cans, and broken
sticks before starting work.
3) Be sure to use the bridge when climbing over steps of about 70 mm or more.
Overcoming a step at high speed may cause a fall accident or breakdown. Be sure to ride
at low speeds and ride the tires perpendicular to the steps. Passing over at high speed is a
very dangerous act as well as causing a breakdown even if the step is 70 mm or less.
4) If the front wheel falls into a hole or groove, be sure to stop the engine without turning
the steering wheel unnecessarily, and then lift this product to escape. Unnecessarily
operating the steering wheel may cause a malfunction.
5) A front wheel collision with a stump, curb, etc. while driving or working may cause a
malfunction.
6) When working under a branch or on a slope, pay close attention to accidents such as being
caught in a branch and falling over.
7) Please note that the knife rotates at high speed.
8) Operate the knife clutch lever slowly.
9) Suddenly setting the knife clutch lever to the "on" position at the lowest cutting height
position (around 10 mm) will lead to premature damage to the cutting belt due to a
sudden overload.
10) When disengaging the knife clutch, be sure to return the knife clutch lever to the "off"
position, wait a few seconds (about 5 seconds), and then move the cutting height
adjustment lever to the "move" position. Please note that the knife may rotate, which may
cause foreign matter such as stones to scatter.
11) Do not deposit grass, leaves, etc. on the engine. Accumulation of these combustibles may
cause a fire or malfunction.
12) 草の量が多く、頻繁にエンストするようであれば、作業速度を落とすか、刈高さを上げて数回に
分けて刈る等してください。
Reference；
1) When using this product for the first time, select a flat ground without foreign matter such as stones,
and slowly mow straight so that the mowing marks overlap a little.
2) The cut grass is discharged from the right side of the product to the rear. Always place trees, pillars,
fences and other obstacles on the left side of the product when mowing near obstacles.
3) When working on gentle slopes, mow so that the plug side (right side of the vehicle body) of the
engine always faces the top (mountain) side. If you mow in the opposite way, the engine oil may
burn and emit white smoke.
To Next Page
Loading...
