Panasonic AJ-D610WBP - Audio; Initial Setting; Playback Level Adjustment (1); Playback Level Adjustment (2)

ELE-53
15. AUDIO
15-1. Initial setting
Menu setting
1. Set
[MENU]
switch to
SET
while pushing the
[SHIFT], [+],
and
[-]
button of the operation panel.
2. Set the Menu mode as shown below.
PAGE: MIC/AUDIO
FRONT MIC : -60dB
REAR MIC CH1 : -60dB
REAR MIC CH2 : -60dB
LINE CH1/ CH2 : +4dB
REAR AUDIO : STREO
MIC LOWCUT CH1 : OFF
MIC LOWCUT CH2 : OFF
EMPHASIS : OFF
LIMITER : OFF
TEST MODE : NORMAL
3. Set the camera recorder switches as follows.
MONITOR SELECT : CH1,ST
AUDIO SELECT CH1 : MAN
AUDIO SELECT CH2 : MAN
AUDIO IN CH1 : LINE
AUDIO IN CH2 : LINE
MIC POWER CH1 : OFF
MIC POWER CH2 : OFF
AUDIO LEVEL VR : CENTER
CUE : CH1
4. Set
SW4701 on AUDIO LCD
board as shown
below.
Pin No. -60dB
(default setting)
-20dB
1 Not Used
2 ON (NR ON/OFF)
3ONOFF
4OFFON
5ONOFF
6OFFON
15-2. Playback Level
Adjustment (1)
BOARD
AUDIO LCD
TP
AUDIO OUT
ADJUST
VR4701
MODE
PLAY
TAPE
VFM3580KM (No.1: 0-14min)
VFM3680KM (No.1: 0-10min)
M. EQ.
Audio Analyzer
SPEC.
NTSC:
PAL:
+4dBu +/- 0.2dB
0dBu +/- 0.2dB
1. Adjust
VR4701
so that the
AUDIO OUT
level is in
the specification.
15-3. Playback Level
Adjustment (2)
BOARD
AUDIO LCD
TP
TP4301 [CH1]
TP4401 [CH2]
ADJUST
VR4301
VR4401
MODE
PLAY
TAPE
VFM3580KM (No.1: 0-14min)
VFM3680KM (No.1: 0-10min)
M. EQ.
Audio Analyzer
SPEC.
-20dBu +/- 0.2dB
1. Adjust
VR4301
so that the level at
TP4301
is in the
specification.
2. Adjust
VR4401
so that the level at
TP4401
is in the
specification.