ELE-43
11. VIDEO I/F (2)
11-1. CAMERA IN Vector
Adjustment
BOARD
VIDEO I/F
TP
VIDEO OUT
ADJUST
EVR
VR404[PB_LEV]
VR407[PR_LEV]
INPUT
CAMERA (Color bar)
MODE
EE
TAPE
-
M. EQ.
Vector Scope
SPEC.
*Center of the vector is on the origin of vector
scope and A=7mV or less.
*Each color is in the inner box
Menu Setting
1. While pressing
[SHIFT], [+],
and
[-]
button and set
the MENU switch to
SET
.
2. Set the Menu as shown below.
PAGE: SERVICE ADJ. 1/2
ECU CONNECT :
EVR
IF ADJ. :
ON
PAGE: KNEE/LEVEL (NTSC only)
SET UP 50/25 : 7.5%
EVR Setting
3. Set the EVR as shown below.
[PB] COM:[02] DATA:[63] ADR:[12]
[PR] COM:[02] DATA:[63] ADR:[13]
4. Connect a vector scope to the
VIDEO OUT
, and
adjust
VR404
,
VR407
and
EVR [
←
←←
←
]/[
→
→→
→
]
so that
the vector center is on the origin of the vector
scope and level is
A=7mV
or less.
<Note>
1. Confirm that the master playback vector
confirmation (VIDEO MAIN) is completed.
2. When adjust confirm that the CAMERA BAR SET
UP is 7.5% or 0% and VIDEO Encoder SET UP is
OFF. (NTSC Only)
3. Do not use the extension board. If the adjustment
is wrong repeat the above adjustments.
<NTSC>
<PAL>
Vector center
Vector scope
center
A
BPF mode
A
BPF mode
Vector center
To Next Page
Loading...
