Panasonic AJ-D610WBP - Setup Level Setting

ELE-14
3-7. Setup Level Setting
BOARD
CAM SYS
TP
VIDEO OUT, CAM OUT
ADJUST
EVR
MODE
CAMERA BAR
M. EQ.
WFM Monitor
SPEC.
Distribution (Setup Level)
NTSC = 7.5% or 7.5%A
PAL, Japan = 0%
Menu Setting
1. Set
[MENU]
switch to
SET
while pressing
[SHIFT],
[+], and [-]
buttons on the operation panel.
2. Set the menu as shown below.
PAGE : SERVICE ADJ.1/2
ECU CONNECT :
EVR
EVR Setting
3. Set EVR as follows to set the VIDEO OUT to the
COMPONENT Y OUT.
1)COM:[1E] DATA:[27] ADR:[00] [Enter]
2)COM:[0C] DATA:[20] ADR:[1A] [Enter]
4. Set EVR as follows.
[ 0% Setup] COM:[1D] DATA:[02] [Enter]
[7.5% Setup] COM:[1D] DATA:[04] [Enter]
[7.5%A Setup] COM:[1D] DATA:[08] [Enter]
5. Set EVR and confirm that the VIDEO OUT, CAM
OUT is following setting.
COM:[1E] DATA:[02] ADR:[00] [Enter]
The setting of setup level
0%
setting
7.5%
setting
7.5%A
setting
VIDEO OUT
(Component
out)
Output in
0%
Output in
7.5%
Output in
0%
CAM OUT
(Composite
out)
Output in
0%
Output in
7.5%
Output in
7.5%
<Note>
Especially, in setting of 7.5%A, be careful of setup
level.
0%, 7.5%A
7.5%
VIDEO OUT Signals
0%
7.5%, 7.5%A
CAM OUT Signals