Panasonic AJ-D610WBP - 3-14.Monitor SYNC Level Adjustment; 3-15.Character Level Adjustment

ELE-18
3-14. Monitor SYNC Level
Adjustment
BOARD
ENCODER
TP
VIDEO OUT
ADJUST
VR101[MON_SYNC_LVL]
MODE
CAMERA BAR
M. EQ.
WFM
SPEC.
NTSC : A = 286mV +/- 6mV
PAL : A = 300mV +/- 6mV
Menu Setting
1. Set
[MENU]
switch to
SET
while pressing
[SHIFT], [+],
and
[-]
buttons on the operation
panel.
2. Set the menu as shown below.
PAGE: MAIN MENU 3/4 -> VIDEO OUT
ITEM: VIDEO OUT SEL: MONI
CHARACTER OFF
3. Connect a Waveform monitor to the
VIDEO OUT
,
and adjust
VR101
so that the Level
A
is in the
specification.
<NTSC>
<PAL>
4. Return the MENU setting as follows.
PAGE: MAIN MENU 3/4 -> VIDEO OUT
ITEM: VIDEO OUT SEL: MONI
CHARACTER ON
3-15. Character Level Adjustment
BOARD
ENCODER, ENC SUB
TP
VIDEO OUT
ADJUST
VR401[CHARA LVL]
MODE
CAMERA BAR
M. EQ.
WFM
SPEC.
As A level 100%,
B = 55% +/- 5%, C = 10% +/- 10%
Menu Setting
1. Set Menu SW to ON.
2. Connect a Waveform monitor to the
VIDEO OUT
,
and adjust
VR401
so that the Level B and C are in
the specification.
A
A
C
B